Applications: Low range dynamic applications, Process control equipment, Test and Measurement, Robotics and Effectors, Laboratory and Research

　　Industries: General Industry

　　Description: The CD1110 series of dynamic torque sensors have extremely low operating ranges protected by mechanical stops permitting an overload of 10 times the F.S. measurement range. The rugged design provides accurate bidirectional torque measurements of rotating components up to 2000 rpm. Optionally the CD1110 can receive an on-board amplifier for high level voltage output. Signal amplification is accomplished before transmission via the slip ring assembly, thus eliminating the noise generated by the contacts. It is also possible to eliminate the contact residual drag torque by placing the transducer sensing element directly in contact with the torque to be measured. With many years of experience as a designer and manufacturer of sensors, Measurement Specialties often works with customers to design or customize sensors for specific uses and testing environments. To meet your needs we also offer complete turnkey systems. The matched components (sensor, power, amplifier and digital display) are formatted, calibrated and ready for immediate use.

　　Features:

　　Ranges from ±0.05 to ±2 Nm (±0.04 to ±1.6 Lbf-ft)
　　Integrated Mechanical Stops
　　Keyed Shaft Mechanical Connection
　　High Level Output Model with Integrated Amplifier

　　典型应用: 低量程动态应用，过程控制，测试测量，机器人，实验室和研究

　　行业: 工业控制

　　产品描述:

　　CD1110系列动态扭矩传感器主要用于超低扭矩测量。产品带有机械限位装置，最大允许10倍满量程过载。坚固的结构设计允许传感器在2000rpm的转速下提供精确的双向扭矩测量。放大输出型号可选，放大处理在通过滑环传输信号之前完成，因而消除了由于接触所产生的噪声。客户还可定制将传感器元件直接与被测扭矩接触的型号，用来消除测量扭矩时产生的接触残留阻力矩。作为拥有多年经验的传感器设计和制造商，MEAS常常与客户合作，按要求定制适合特殊用途和测试环境的传感器。同时，我们也根据客户需要提供成套系统。配套元件（传感器，电源，放大器和数显系统）配置统一，经过校正，可供客户立即使用。

　　特点:

　　量程：±0.05Nm ~ ±2Nm（±0.04Lbf-ft ~ ±1.6Lbf-ft）
　　机械限位
　　插销式机械连接
　　可选放大输出

　　CD1110系列动态扭矩传感器更多技术参数及规格书下载请浏览：http://www.sensorway.cn/sensors/558.html
　　
　　北京赛斯维测控技术有限公司产品咨询热线：010-84775646，84775648。